Step-by-Step Guide to Installing Your New Jolie Shower Head- A Hassle-Free Process!

How to Install Jolie Shower Head

Installing a new shower head can be a simple and rewarding DIY project that can significantly enhance your bathroom experience. If you’ve recently purchased a Jolie shower head and are ready to install it, follow these step-by-step instructions to ensure a hassle-free installation.

Materials Needed:

Before you begin, gather the following materials:

– New Jolie shower head
– Adjustable wrench
– Screwdriver (flat-head or Phillips-head, depending on the type of screws)
– Teflon tape or plumber’s tape
– Duct tape or plumber’s putty (optional, for additional seal)

Step 1: Turn Off the Water Supply

First, turn off the water supply to the shower. This can typically be done by turning the valves located behind the wall where the shower head is attached. If you’re not sure where these valves are, you may need to consult your home’s water supply diagram or seek assistance from a professional plumber.

Step 2: Remove the Old Shower Head

Once the water supply is turned off, remove the old shower head. This can usually be done by unscrewing it counterclockwise. If the shower head is stuck, apply a little lubricant to the threads and wait a few minutes before trying again. If the shower arm is threaded, you may need to use an adjustable wrench to loosen it.

Step 3: Clean the Shower Arm

After removing the old shower head, clean the shower arm thoroughly. Remove any old plumber’s tape or debris that may be present. This will ensure a secure and leak-free connection for the new shower head.

Step 4: Apply Teflon Tape

Wrap a length of Teflon tape around the threads of the shower arm. This will create a tight seal and prevent leaks. Make sure to apply the tape in a clockwise direction, starting from the end of the shower arm and working your way down to the threads.

Step 5: Install the New Shower Head

Attach the new Jolie shower head to the shower arm by screwing it on clockwise. Use your hands at first, then apply gentle pressure with an adjustable wrench if needed. Ensure that the shower head is securely fastened.

Step 6: Test for Leaks

Turn the water supply back on and check for leaks. Look for any signs of water dripping from the connection points. If you notice a leak, tighten the shower head or the shower arm slightly until the leak stops.

Step 7: Secure the Shower Arm (Optional)

If you want to add an extra layer of security, you can apply plumber’s putty or duct tape to the shower arm where it meets the wall. This will create a more secure seal and reduce the risk of future leaks.

Congratulations, You’re Done!

You’ve successfully installed your new Jolie shower head. Enjoy the improved water pressure and design of your shower. If you encounter any issues during the installation process, don’t hesitate to consult the manufacturer’s instructions or seek assistance from a professional plumber.